identifying engine mounts

[frm2frk]

These engine mounts are on our 1978 Cal 2-25 with a Yanmar YSM8 inboard. Anyone recognize the mounts used here? The stud is 5/8", arount 4.5" tall overall, with mounting bolts 4" apart. I believe they may be Vetus but it would be nice to have a second set of eyes look at them, especially from others familiar with Cals. I had planned on replacing them this past week, and thought I was smart by buying Yanmar mounts, but the measurements were way off once I got to the boat. That was the moment I realized I was not so smart by not referencing measurements and photos more closely prior to.

PXL_20230402_204252227.jpg (2.99 MiB) Viewed 10013 times

Additionally, does anyone have a recommendation on engine mounts to use? I've come across Vetus, Barr Marine, Bushings Inc, and maybe one or two others with same measurements as the current ones.

Thanks!

[kjndave]

For the pictures they do look like Vetus mounts, but I've not used Vetus so it's just a comparison of pictures.

I am in what I hope to be the final steps in my repower to replace the original Farymann engine with a Yanmar 2GM20F in my Cal 2-29. I opted for OEM Yanmar engine mounts. I got a set which has both the front and rear mounts as specified. (Different "shore: values for the rubber/neoprene.)

I had new rear engine mount brackets (The part that bolts to the block and actual mount.) made to move the mount out a bit.
I had the front mounts modified to also move them out and back 1.5 inches. The mounts now fit nicely on the stringers, or they should once I get time to install them.

[Capn ken]

Howdy ,My cal 29 has an atomic 4 that I am quite comfortable with . it has 154 hrs since I overhauled and balanced the engine . The motor mts were replaced at the same time . Sadly I can't remember the brand .